I can slice in multi , trim to zero crossing on start and end then trill a pad while in the editor , and it will sound fine.
As soon as I exit the editor though and am in say, just mixer mode , and trill the exact same trimmed pad , I get clicks when trilling.
I’m assuming this is a bug ?
1 Like
I’m don’t think that’s what’s happening ?
Again they rea fine in the editor , when I’m come out is when I get clicks , none of the start and end points are near each other.
Unless the end point is the same as the next start point and aren’t separate markers.
I explore more just in case
1 Like
This - ‘Unless the end point is the same as the next start point and aren’t separate markers’
2 Likes
Hello, I think I have the same issue
Look in my post:
And I think this is happening because the file is more then 2mb , try with files smaller than 2mb… if you sampled you can see the file size in the track information
I haven’t tested it yet but I think that’s why, I have to test it