I am updating DSP firmware from 3.0.28 to v3.0.35 and Machine is stuck.
It has been almost 1 hour, There is a white square that looks like a progress bar in Lower left of display. It was successful updating the 2400’s firmware the other day. This is the first DSP firmware update I attempted
I did check power cable to see if it was touching the ribbon cable and it is not
-there is a red led flashing on the card behind the display
as well on the main board under the dsp card
Not sure what I should do.
If it has been sat for that long then switch the machine off, remove the SD card and check the DSP version once it’s rebooted.
SHIFT+Effects > Card Version.
the DSP contains a ‘shadow’ copy of the firmware which doesn’t get overwritten unless the firmware update was successful.
Does it display the correct version? If not, please try updating the firmware again.
I shut it down, to see if it would boot by changing the file name… But it booted up fine when I powered it back on, So with the OS firmware booting, I re-downloaded the DSP firmware and deleted the file I attempted to use, It loaded the new firmware for the DSP card then the OS firmware with no problems.
