Hey, just updating to the latest firmware and its been going for over 2 hours. Assume thats not right as usually much quicker? Scared to turn it off. What should I do?
I was upgrading from Feb’s to the latest firmware. I have DSP installed. I copied DSP update and the latest firmware via USB and it automatically detected and offered installation. When installation started the USB mode was obvs disabled but the USB cable still connected - not sure that makes a difference.
Any ideas?
Its now just a blank screen 
Resolved. panic over.
what was your issue?
Hey mate, I was just updating the firmware, the screen showed but no loading bar. I left it for a few hours. Popped out and when I got back the screen was blank.
I followed the instructions on the original post about updating firmware - turned it off and on again, which gave me the long blank screen while it reloads, after that it did a really long fan spin. Turned it on and off again, firmware was updated and is fine now. So all good.
Was probably over reacting, sorry! Never had any issues before and was just worried about turning it off midway through an update.
Thanks