2020-12-16 firmware
Here is the issue im having and how i arrived to it. it is repeatable.
*note I have 1/4 in cable plugged into main left and right outs and outputs 7 and 8.
assign sample (approx 2 min long) to pad one (set to channel 1). test it, by hitting the pad, i can hear it just fine.
assign a different sample to pad 8 (also approx 2 min long, set to channel 8) . test it, by hitting the pad, i can hear it just fine.
enter the waveform slice view on pad/sample 1. test it, press the pad while moving around the start point. can hear it. everything normal so far.
enter waveform slice view on pad/sample 8. press pad while in this view while moving around start point, no audio. dosnet matter where the end and start points are, no audio i heard no matter what while in this view… exit that view and hit the pad, i can hear it again.
enter the waveform slice view on pad/sample 1 again. test it, press the pad while moving around the start point. this time no audio while viewing this sample either. same thing as above, as soon as i back out of the wavefrom view i can hear audio again.
*the second time i tried to repeat this bug, i somehow managed to get to a screen that said something like “audio board error” or audio board com error" or something along those lines and was forced to reset. I can repeat above steps and get the same results every time. i have not been able to get that error and forced reset to happen again though.
I’m also on 2020-12-16 firmware, but I cannot recreate this issue following your steps. The only other settings I made is having my pad A1 Channel & Alt.Channel settings set to 1, and my Pad A8 Channel & Alt.Channel settings set to 8. Are you working with stereo or mono samples?
Just tried it with stereo samples and I was able to reproduce the same bug. No matter what output (1-8) I assign the 2nd stereo sample to, I cannot hear it in Loop/Slice waveform view. Only the 1st sample assigned to pad A1 outputs audio in waveform view.
Also what’s interesting is that I swapped the samples from pad A1 to A8 and now A8 only plays in waveform edit. So somehow the 2nd sample loaded is affected
I have confirmed this bug. Only seems to happen with stereo samples, and happens even if only one is loaded.
Thanks for the bug report. We will work on it.
thanks for the confirmation guys. this is a pretty major issue for me personally since all the samples im working with and imported are stereo… and i really rely heavily on that waveform view. pretty much put me on hold using it until it gets taken care of.