Please make the clock send a start signal when TRS is used

strange to put this as a feature request, seems pretty standard but hey.

can you make this work please, having to set slaves up into wait/pause mode down stream goes against TRS - if i was using TS cables i could understand.

it responds and sticks like glue to anything sending a start signal via trs but it cannot send that start signal out


with TS and TRS you mean the 1/8" clock in/out jacks? these are TS only, there is no way to send anything on the R-ing

yes the 1/8 jacks and ok thanks AV, it receives on the ring though - shame but at least i know now thanks again