I found another issue (or 2) in step edit mode for midi notes. Latest firmware.
I started out with a 2 bar pattern. No samples loaded, all banks empty. Goto bank E, pad E1, multimode pitch.
Recorded a simple 2 notes sequence, one note at the start of each bar, ending at the 3rd beat to let the synth go into release mode. While recording it, everything was sounding fine. Also the length of the notes is displayed correct in the step program screen.
I go out of record mode and the notes suddenly are way shorter sounding. The release is kicked in before the 2nd beat of each measure. The display shows it still good, but the midi is not sent out correctly. I think this is a possible bug.
So I go into the step editor to look at the values of the length of the notes. These lengths were too short (<100), so I tried to extend them. I think I rotated to increase the length, but I might have placed a new step in step program (not sure) and all of a sudden I hit the max value (65536). That is way to high, so I try to decrease it, by rotating the encoder (I should have entered a value with the numpads, but that’s what comes to mind later…) It now seems to be impossible to get below 65000. But that is a window refresh issue. When getting close to zero, the display now shows “65 2”. So the length field is not fully equipped to handle more than 3 digits in all scenarios.