Hey I am still getting bleed from the individual outs to the main outs on the DSP S2400. I’m running the latest firmware for both the machine and DSP card. It seems this was fixed in a previous firmware release but I am getting bleed again now. I have a mono track, pad 5, assigned to individual out 5, and then a cable is plugged in there. Everything else is stereo and assigned to outputs 1 and 2, except pad 5, yet I still hear pad 5 on main outputs 1 and 2. Thank you very much,
Greg
@av500 can you shed any light on this?
with the DSP card installed, plugging an individual out does not remove it from the main mix, you have to do that in the DSP mixer settings for that channel
I’ve just been using the individual outs since I posted to avoid this issue. I should make sure I’m doing it correctly before trying the main outs again. I wasn’t simply plugging in the individual outs. On the pad settings I was also assigning the correct corresponding individual outs, yet was still hearing bleed on the main outs. To avoid this I need to go to the DSP mixer?
with the DSP card installed, plugging an individual output does not remove that signal from the main mix as the main mix is now done on the DSP board, so you need to remove that output channel from the main mix in the DSP mixer page