Hey guys, do i overlook this possibility or isn’t it implemented (yet)? After i switch of the S2400 it restart “empty” is it possible to start the machine up with the last project i was working on?
Thanks already, looking forward to the answer(s)
Hey guys, do i overlook this possibility or isn’t it implemented (yet)? After i switch of the S2400 it restart “empty” is it possible to start the machine up with the last project i was working on?
Thanks already, looking forward to the answer(s)
Yes, it’s in the settings menu
where exactly? I can’t find… overlooking again?!
I’m not in front of the machine at the moment but I think it’s something like “load @ start” or something
I’m dump… searching everywhere but not reading at all… Thank you!