When setting up a Live Loop I try to change the output destination and while in the menu it’ll look like it’s going to the new location but when backing out of the settings menu and going back into it, it’ll revert to how it was before. Example: I’d change it from outputs 1 & 2 to 3 & 4 and then I press the Back button. Then Shift and Pad 1 and the output will be 1 & 2.
I only notice this when Stereo live loop is turned on, seems if live loop is set to Mono output the change sticks.
Furthermore, it seems tied to the pad grouping. So if I have 8 loopers and in stereo, pads 1 and 2 output to outputs 1 and 2, 3 and 4 go to outputs 3 and 4, ect. But they always revert back to the original setting after I attempt to change.
Finally, if I change the Output in Mono mode and then reconfigure to Stereo mode the Output changes seem to stick. So if I set pad 3 to go to output 7, then switch to Stereo and then Reconfigure the live looper, and I go into pad 3s setting it’ll say it’s outputting to outputs 7&8.
I believe that’s the extent of the bug.